Toe Nail Removal Trainer
Ingredients
- 108 ml Dragon Skin Part A (Smooth-on)
- 108 ml Dragon Skin Part B (Smooth-on)
- 54 ml Dragon Skin Part S (Smooth-on)
- Mold Release (Smooth-On)
- Silc Pig Flesh Pigment (Smooth-On)
- Plastic Cups
- Stirrers
- Scale
- Baby Powder
- 3d Printed Toe Nail Removal Mold (STL in downloads)
- 3d printed TPU Toenail Insert (STL in downloads)
Instructions
- Assemble both sides of the mold and insert the top piece into its aligning holes with the peg positioned in the big toe.
- Thoroughly spray mold release into the mold, making sure to get all the crevices and corners
- Put plastic cup on scale and tare the scale
- Pour 108 ml of Part B into the cup
- Insert desired pigment into the cup until you reach the desired skin tone
- Use a stirrer and mix the pigment and Part B together (leave stick in the cup)
- Tare the scale again
- Pour 54 ml of Part S into the cup. Thoroughly mix together until fully combined, making sure you scrape down the sides of the cup.
- Tare the scale again and spray the mold with mold release a second time.
- Pour in 108 ml of Part A, and thoroughly mix making sure there are no clumps or pockets of unmixed dragon skin.
- Pour the mixture into the mold. There is a 12 minute pot time before the mixture starts curing.
- Let the part cure completely for 40 minutes.
- Pull the top insert out of the mold and part then separate the mold into halves to pull the part out.
- Use a paper towel to wipe off any mold release residue left on the part.
- Once dry, put baby powder on the foot to remove tackiness and to give a flesh-like feel.
- Cut a hole in the nail bed of the big toe until you hit the cavity left in the part
- Insert the toenail insert into the hole and pull it through the hole in the nail bed.
- After use of toenail, dispose of old part and insert a new Toenail.
