Patches
Dragon Skin for one patch. ~2mm thick with a ~6 inch diameter. It is used as an overlay and stretched over the surface.
Ingredients
- Dragon Skin Part A (Smooth-on) 15 ml
- Dragon Skin Part B (Smooth-on) 15ml
- Dragon Skin Part S (Smooth-on) 12 ml
- Mold Release (Smooth-on)
- Flesh Pigment (Smooth-on)
- Plastic Cups
- Stirrers
- Scale
- Baby Powder
- Paper Plate (wax coated)
Instructions
- Spray mold release evenly onto the paper plate
- Put a plastic cup on the scale and tare (zero out) the scale
- Pour 15 ml of Part B into the cup
- Add flesh pigment of choice and mix until desired skin tone
- Tare the scale again
- Pour 12 ml of Part S into the cup
- Mix and scrape down the sides of the cup to ensure an even mixture
- Tare the scale once again
- Pour 15 ml of Part A into the cup
- Mix thoroughly and make sure there’s no unmixed dragon skin. It take 12 minutes to start curing
- Once evenly mixed, start pouring the mixture onto the plate.
- Let it cure for 40 minutes
- Once cured, remove the dragon skin carefully from the plate.
- Use a paper towel to wipe off any mold release residue
- You may apply baby powder or leave as is for tackiness
